OBJECTIVE
To lay down the procedure for the operation and cleaning of the Face Mask Making Machine.
RESPONSIBILITY
Officer/Executive Production: Shall be responsible for the operation and cleaning of the Face Mask Making Machine.
Manager-Production: To ensure that the procedure is properly followed.
SCOPE
The procedure applies to the Facemask Making Machine located in the face mask manufacturing division at Pharmasky Ltd.
PROCEDURE
Operation
- Turn on the power switch and the power LIGHT will get on.
- Non-woven fabrics suitable for machine-compliant production must be used.
- Put the nonwoven coil into the discharge mechanism and adjust the good volume to the center of the machine.
- Pass the cloth through the guide rollers.
- Set the indentation and cursor tracking position.
- Set the correct parameters for the machine and start-up commissioning.
- After all parts have been debugged, press the start switch to turn on the machine and make mask production.
- The machine will automatically complete all the set procedures, including feeding, folding, heat hot handle, indentation, correction positioning, cutting, forming part and ultrasonic heating will be carried out automatically.
- If necessary, the emergency stop switch can be pressed to completely stop the machine. When the emergency stop switch is pressed, the machine stops all work.
Cleaning
- Clean the machine housing with a damp cloth to remove foreign material attached to the ultrasonic assembly.
- Clean the ear rope powder that remains at the shear rope with a semi-wet cloth.
- Do not use a high-voltage cleaner.
- Clean ear rope shear residue.
- The powdery residue of the ear rope at the cutting requires a gun vacuum cleaner or wipes it with a clean semi-wet cloth.
ABBREVIATIONS
SOP: Standard operating procedures
No. : Number
REVISION HISTORY
Nil
PEOPLE ALSO READ: SOP for Cleaning and Operation of Vial Washing Machine
0 Comments