SOP for Operation and Maintenance of Vortex Mixer

Objective

To define the operation of the instrument for better and error-free use of the same.

Scope

To describe the procedure for the installation, operation and maintenance of Vortex Mixer

This procedure is applicable to mix the solution or to dissolve the various substance into the solvent.

Responsibility

Doing: Technical Assistant / Executive

Checking: Executive/Manager

Accountability

Head of the Department

Procedure

Installation

Place on a level surface and plug cord into mains supply.
Place desired attachment onto the shaft and rotate until the ‘flats’ align.
Press the attachment down firmly until it snaps into place.
Grasp and pull straight up the installed attachment until it is released from the shaft if another type of attachment needs to be used.

Operation

Continuous Operation

Push switch to the ‘ON’ position.
Turn speed control knob to setting No.3 on the dial.
Observe that the attachment is immediately set in motion.
Place the sample tube on top of the attachment and keep steady.
Vary the speed on the dial and/or the angle of contact and pressure against the mixing attachment to achieve the desired mix.
Return switch to the ‘OFF’ position once finished.

Intermittent Operation

Push switch to the ‘TOUCH’ position.
Turn speed control knob to setting No.3 on the dial.
Touch the sample tube with the attachment to observe motion and keep steady.
Vary the speed on the dial and/or the angle of contact and pressure against the mixing attachment to achieve the desired mix.
Return switch to the ‘OFF’ position once finished.

Maintenance

Unplug the mixer from its power supply before attempting any cleaning measures.
Keep the unit clean by immediately blotting any spills.
Use a moistened cloth or sponge with a mild detergent to clean the outside surface.
Replace rubber attachments with new ones when these show progressive signs of wear.

Precautions

The mixer may become warm to touch when in constant use, however performance will not be affected.
Do not lift the mixer from its removable rubber attachments.
Avoid wetting and unnecessary exposure to fumes.

Revision History

Nil