Header Ads Widget

SOP for Cleaning Procedure for Disintegration Test Apparatus

OBJECTIVE
To lay down the procedure for cleaning of Disintegration Test Apparatus

SCOPE
This SOP shall be applicable for Disintegration Test Apparatus installed in Quality Control Laboratory at XYZ Limited

RESPONSIBILITY
Execution : Chemist and above-QC department

PROCEDURE
Frequency:
Assembly : After every use.
Water Bath : Once in a week or when required.
  • Switch ‘OFF ’the instrument.
  • Remove the temperature probes from the instrument.
  • For cleaning of Assembly
  1. On completion of every disintegration test, remove the jars and basket assembly along with discs.
  2. Wash them properly with water and keep aside.
  • For water bath
  1. Switch ‘OFF’ the mains and remove the main plug from the socket, unscrew the top plate of the water bath.
  2. Remove the water bath and take water bath near the tap water.
  3. Wash it with tap water and then with detergent and again it with tap water until no foam of detergent remains in bath.
  4. After complete removal of all detergent, wash the water bath with water.
  5. Place the water bath to its original place.
  6. Fill the water bath with water up to the mark.
  7. Record the details of cleaning in log book of instrument as per current version of SOP.
Note: In between when water becomes dirty, change water of water bath.

ABBREVIATION(s)
SOP : Standard Operating Procedure
Q.C Quality control

ANNEXURE(s)
Nil

REVISION CARD
Nil

Post a Comment

0 Comments

close