HOT POST

50/recent/ticker-posts

Header Ads Widget

SOP for Operation & Performance Check Procedure for Water Purification System

OBJECTIVE
To lay down the procedure for Operation & Performance Check of Puris water purification system for better and error free use.

SCOPE
This procedure is applicable for Puris water purification system installed in Q.C. Department at XYZ Limited

RESPONSIBILITY
Execution – Chemist and above -QC Department
Checking - Asst. Manager and above -QC Department

PROCEDURE
OPERATION PROCEDURE
  • Switch ‘ON’ the mains.
  • Switch ‘ON’ the instrument.
  • Open the valve for RO water system
  • Press the UP ON/OFF Key for 5 sec
  • Press the UP ON/OFF Key again to produce estimated amount of water
  • Press menu key to stop working

PERFORMANCE CHECK PROCEDURE:


  • Operate the instrument as per operating procedure mentioned above.
  • Take the required quantity of sample of water to perform the tests for determination of pH, conductivity, Total coliforms, Fecal coliforms and for Total Viable Count
  • Record the results of the above mentioned tests as per Annexure-1

Replacement of filter and membranes of Lab Water system and RO system
  • Filter and membranes of Lab Water system & RO system shall be changed as per frequency mention below and record shall be maintained as per annexure-2

ABBREVIATION(s)
SOP : Standard Operating Procedure
No. : Number
Dept. : Department
QC : Quality Control

ANNEXURE(s)
Annexure No. - 1 -- Performance check report of water purification system
Annexure No. - 2 -- Filter/membrane replacement record


REVISION CARD
Nil

Post a Comment

0 Comments

close