HOT POST

50/recent/ticker-posts

Header Ads Widget

SOP for Ultrasonic Bath (Model: WUC-D104)

OBJECTIVE
To lay down procedure for Operation of ultrasonic bath for better and error free use

SCOPE
This SOP is applicable for ultrasonic bath installed in Quality Control Department at XYZ Limited.
RESPONSIBILITY
Execution : Chemist and above – QC department.
Checking : Asst. Manager and above – QC department

PROCEDURE
Operational Procedure
  • Ensure that surrounding working area is clean.
  • Check that the instrument is connected to the power supply.
  • Check that distilled water is filled in ultrasonic batch up to 1/4th of the total depth
  • If water is hazy or dirty drain the water from outlet valve provided on the right side of the instrument and replace with fresh distilled water.
  • Switch on the mains and then switch ON the instrument by ON / OFF key provided on the front side of the instrument and ensure that the instrument is working properly.
PEOPLE ALSO READ: SOP for Operation of Water Bath
  • Control the strength of sonication from power controller.
  • Select the TIME by MODE button and set the operating time by UP/DOWN button.
  • Select the TEMP by MODE button and set the operating temperature by UP/DOWN button.
  • After inputting all parameters, push the START/STOP button to start sonication.
Precautions
  • Never operate an empty bath
  • Always remove mains plug from supply when emptying the bath
  • Never use toxic, flammable, acidic, corrosive solutions.

ABBREVIATION(s)
SOP : Standard Operating Procedure
Q.C : Quality control

REVISION CARD
Nil

Post a Comment

0 Comments

close